Initial Setup; Turning The Unit On; Turning The Unit On For The First Time - Venturer PLV3117i Owner's Manual

INITIAL SETUP

Turning The uniT On

When you turn on your television set for the first
time, be sure to place it on a solid stable surface. To
avoid danger, do not expose the TV to water or a heat
source (e.g. lamp, candle, radiator). Do not obstruct
the ventilation grid at the rear and be sure to leave
sufficient gaps around the unit.

Turning The uniT On fOr The firsT Time

The first time for you turning on the unit, the unit will enter Virgin mode. You can easily follow up prompt
message on screen to finish basic TV settings of the system.
Make sure RF aerial has been connected properly to the TV anTenna input jack on the rear of the
system.
1. Press the / button to select Tuning mode. AIR
(over-the-air broadcasts, CH 2-69), CATV (cable/
satellite broadcasts, CH 1-125), HRC (CH 1-125) or
IRC (CH 1-125) mode are available.
2. Use the / button to highlight Auto Tune.
3. Press the button to begin auto scan. The system will
automatically start to scan and preset all available TV
channels.
4. After scaning finished, the system will return to the first TV channel scaned just now.
E - 16