Attaching The Foot Stand (Optional); Connecting The Handset; Connecting The Headset (Optional) - Nortel 1230 User Manual

Installing your IP Phone 1230

Attaching the foot stand (optional)

Attach the foot stand in the appropriate slots, depending on the desired
angle for your IP Phone. If you insert the foot stand into the upper slots,
your IP Phone sits at a 25-degree angle. If you insert the foot stand into
the lower slots, your IP Phone sits at a 55-degree angle.
If you install your IP Phone on a wall, do not attach the foot stand.
1. Align the bottom tabs on the foot stand with the position 1 slots or the
position 2 slots on the back of your IP Phone.
In position 1 the IP Phone sits at a 25-degree angle.
In position 2 the IP Phone sits at a 55-degree angle.
Figure 4 on page 35
2. Press the foot stand into the slots until it snaps into place.

Connecting the handset

Use the following procedure to connect the handset to the IP Phone 1230.
1. Plug the end of the handset cord with the short straight section into
the handset.
2. Plug the other end of the handset cord with the long straight section
into the handset jack marked with the
Phone.
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.
Figure 4 on page 35
IP Phone 1230.

Connecting the headset (optional)

If you have a headset, you can connect the headset to the
IP Phone 1230. For information on how to use your headset with your IP
Phone, refer to "Using a headset" on page
36
shows the slots on the back of the IP Phone.
shows the connections on the back of the
+ symbol on the back of the IP
96.