Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Button Remotes - Chamberlain 3595S 3/4 HP Owner's Manual

PROGRAMMING

Your garage door opener has already been programmed at the factory to operate with your hand-held
remote control. The door will open and close when you press the button shown.
Below are instructions for programming your garage door opener to operate with additional
895MAX remote controls. To program additional remote controls, refer to the instructions
provided with the remote control.
To Add or Reprogram a Remote Control (Model 895MAX)
USING THE SMART CONTROL PANEL
2.
Press and release the Prog <Learn> button on the Smart
Control Panel ®
twice. Within 30 seconds...
Prog <Learn> Button
3.
Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb
blinks. If not, wait for the remote control LED to light
solid then slowly press and release the remote control
button again. Repeat until the light bulb blinks. DO
NOT press the button after the light bulb blinks.
4.
To exit programming mode, press any remote control button except the button that was just programmed.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, fi rst erase all codes:
Press and hold the "learn" button on motor unit until the learn indicator light goes out
(approximately 6 seconds). All previous codes are now erased. Reprogram each remote or
keyless entry you wish to use.
NOTICE: If this Security✚
in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
® garage door opener is operated with a non-rolling code transmitter, the technical measure
1.
To enter programming mode, press the Program
button until the LEDs on the front of the remote control
turn on.
Safety Pin or
Paper Clip
® OR
2.
Press and release the Learn button on the garage door
opener. The Learn LED will light. Within 30 seconds...
31
Factory Programmed Button
USING THE "LEARN" BUTTON
Learn LED
LEDs