Using The Wall-Mounted Door Control - Chamberlain 3595S 3/4 HP Owner's Manual

Using the Wall-Mounted Door Control

THE SMART CONTROL PANEL
Press the push bar
to open or close the
door. Press again
to reverse the door
Prog
during the closing
<Learn>
cycle or to stop
the door while it's
opening.
Minute
This door control
contains a
Language
motion sensing
detector that will
Degrees (F/C)
automatically turn
on the light when it
detects a person entering the garage.
Light Feature
Press the Light button to turn the opener light
on or off. It will not control the opener lights
when the door is in motion. If you turn it on
and then activate the opener, the light will remain on for
4-1/2 minutes. Press again to turn it off sooner. The 4-1/2
minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2
minutes as follows: Press and hold the Lock button until
the light blinks (about 10 seconds). A single blink indicates
that the timer is reset to 1-1/2 minutes. Repeat the
procedure and the light will blink twice, resetting the timer
to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval,
etc., up to a maximum of four blinks and 4-1/2 minutes.
When using the opener lights as working lights, we
recommend that you fi rst disable the motion sensor.
See Automatic Light Feature, below.
Motion Sensing (Automatic Light Feature): The opener
light will turn on automatically when a person enters the
garage. When a person walks in front of the door control,
the light will come on for fi ve minutes, then shut off. This
feature works by detecting body heat.
To disable this feature, push the motion
sensing button on the side of the door
control.
We recommend that you disable the motion
sensor when using the opener lights as working lights.
Otherwise, they will turn off automatically if you are
working beyond the sensors range.
Lock Feature
Designed to prevent operation of the door
from hand-held remote controls. However,
the door will open and close from the Door
Control, the Outdoor Key Switch and the Keyless Entry
Accessories.
To activate, press and hold the Lock button for 2 seconds.
To turn off, press and hold the Lock button again for 2
seconds. The Lock feature will also turn off whenever the
"learn" button on the motor unit panel is activated.
®
Motion
Sensing
On/Off
Hour
Lock Button
(PROG) Learn Feature
The door control is equipped with a PROG <LEARN>
button to assist in learning remote controls to the unit.
Press the PROG <LEARN> button once to initiate LEARN
mode and the display will show 'Learn Remote Control -
Press Learn Button Again to Confi rm'. Press the
Push
Bar
PROG <LEARN> button a second time and the display will
show 'Learn Mode - Press Remote Control Button to Learn
Remote.' Press the button of the remote control to be
learned and the worklight will blink to confi rm the remote
control has been learned.
Light
Button
(LANG) Language Feature
Press this side button to toggle between the three
languages - English, French and Spanish.
Degrees F/C Feature
Press this side button to toggle the
temperature units between Fahrenheit
and Celsius.
Display Contrast Adjustment
Press and hold the light button then push the hour button
to increase the contrast or the minute button to decrease
the contrast.
25
Hour & Minute Feature
Press or hold either of these side
buttons to increment the hour or
minute displayed on the LCD display.