Smart Control Panel ® Messages; Operation - Chamberlain 3595S 3/4 HP Owner's Manual

Smart Control Panel
The following messages are contained within the Smart Control Panel
Message
SAFETY SENSORS
CHECK ALIGNMENT,
BLOCKAGE OR
MISWIRING. SEE
OWNER'S MANUAL.
Message
SAFETY SENSORS
MALFUNCTION.
CHECK MISWIRING.
SEE OWNER'S
MANUAL.
Message
LEARN REMOTE CONTROL.
PRESS LEARN BUTTON TO
CONFIRM.
Message
LEARN MODE.
PRESS REMOTE
CONTROL BUTTON TO
PROGRAM REMOTE.
Message
LOCK MODE. REMOTE
CONTROL LOCKED OUT.
PRESS LOCK BUTTON TO
ENABLE REMOTE.
Message
ENGLISH, FRANÇAIS AND
ESPAÑOL.
Message
MOTION SENSING ON,
MOTION SENSING OFF.
®
Messages
Meaning: This message will appear if the Safety Reversing Sensors are out
of alignment, if they are blocked or if the wiring is disconnected. To clear
message from Smart Control Panel
• Check to see that area is clear between the Safety Reversing Sensors.
• Check to see that the Safety Reversing Sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is fi rmly secured to wall and does not move.
• Check to see that the Safety Reversing Sensor wires are connected to the
motor unit.
• If message has not cleared after the above checks, refer to message #2.
Meaning: This message will appear if the Safety Reversing Sensors are
miswired. To clear the message, do the following:
• Inspect the safety reversing sensor wires for a short (staple in wire), correct
wiring polarity (black/white wires reversed), replace/attach as needed.
• Disconnect all wires from back of motor unit.
• Remove safety reversing sensors from brackets and shorten sensor wires to
1-2 ft. (30-60 cm) from back of each sensor.
• Reattach sending eye to motor unit using shortened wires. If sending eye
indicator light glows steadily, attach the receiving eye.
• Align sensors, if the indicator lights glow replace the wires for the sensors.
If the sensor indicator lights do not light, replace the safety reversing sensors.
Meaning: This message will appear when the Prog <LEARN> button has been
pressed on the Smart Control Panel
again will allow the user to program an additional remote control to the
opener.
Meaning: This message will appear when the Prog <learn> button has been
pressed a second time on the Smart Control Panel
The opener is ready to program another remote control by simply pressing the
remote control button. Once the opener has 'LEARNED' the remote control,
the worklight will blink one time.
Meaning: This message will appear when the 'Lock' button has been pressed
and held for more than one second. This feature will disable the opener from
receiving remote control signals. To exit 'LOCK' mode, press and hold the
button for more than one second.
Meaning: This message will appear when the 'Language' button has been
pressed. Pressing the button will toggle to the next language.
Meaning: This message will appear when the 'MOTION SENSING' button
is pressed. The Motion Detector will toggle on or off with each press of the
button.
® and may appear during the operations of the unit:
® do the following:
® . Pressing the Prog <LEARN> button
30
®
or anytime on the opener.