Table of Contents
Advertisement
PROGRAMMRNG
NOTICE:
if this Security't ,_ garage door opener is operated
with a non-rolling
code remote control
the technical
measure
in the receiver
of the garage door opener, which provides
security against code-theft
devices,
will be
circumvented.
The owner of the copyright
in the garage door opener does not authorize
the purchaser
or supplier
of the
non-rolling
code remote control to circumvent
that technical
measure.,
Your garage door opener has already been programmed
at the factory to operate with your hand-held
remote control,,
The door will open and close when you press the large push button,
Below are instructions
for programming
your opener to operate with additional
Security.I ,° 315 MHz remote controls.
To Add
or Reprogram
a Hand.held
Remote
Control
USING THE "LEARN"
BUTTON
USING THE MOTION
DETECTING
DOOR CONTROL
1,, Press and release the "learn" button on
the motor unit., The learn indicator light
will glow steadily for 30 seconds,
2. Within 30 seconds, press and hold the
button on the hand-held remote* that
you wish to operate your garage door.,
3. Release the button when the motor unit
lights blink., It has learned the code, If
light bulbs are not installed, two clicks
will be heard,,
.. I /
I. Press and hold the button on the
hand-held remote* that you wish to
operate your garage door,
2,, White holding the remote button, press
and hold the LIGHT button on the
Motion Detecting Door Control,
3, Continue holding both buttons while
you press the push bar on the Motion
Detecting Door Control (all three
buttons are held),
4o Release buttons when the motor unit
lights blink It has learned the code, If
light bulbs are not installed, two clicks
will be heard..
..,I
/
To Erase
All
Codes
From
Motor
Unit
Memory
To deactivate any unwanted remote, first
erase all codes:
.
_.___
I I
Press and held the learn" button on motor I
"_ ![--It
I t
unit until the learn indicator light goes out ]
I _
I I
(approximately
6 seconds)° Alt previous
]
I _::A::qlI J
codes are now erased, Reprogram each
I
_f(
}_ J t
remote or keyless entry you wish to use.
]
k__
1./ I
*3.Button
Remotes
(315
MHz)
If provided with your garage door opener, the large button
is factory programmed
to operate it.. Additional buttons on
any Security÷ ® 3-button
.t"_/__,._
_
remote or mini-remote can
be programmed to operate
other Security÷ e garage
,
doo
I
37
Advertisement
Table of Contents
