Step 4 : Connect To The Computer With A Parallel Cable - Samsung ML-1451N User Manual

Connect to the Computer
with a Parallel Cable
1
Make sure that both the printer and
the computer are turned off.
2
Plug the parallel printer cable into the
connector on the back of the printer.
Push the metal clips down to fit inside
the notches on the cable plug.
3
Connect the other end of the cable to
the parallel interface port on your
computer, and tighten the screws.
See your computer documentation if
you need help.
Note: To connect the printer to the parallel port of the computer requires a certified parallel cable.
You will need to buy the IEEE1284 compliant cable.
If you are using a USB interface
Go to page 2.17, "Installing USB Driver."
Note: USB cable shorter than 3m is recommended.
If you are using a network interface
Go to page F.5, "Network Interface Card."
Notes:
• ML-1451N comes with a built-in network interface.
• Shielded cables must be used with this equipment
to maintain compliance with the EMC Directive (89/336/EEC).
2.8 S U Y P
ETTING P OUR RINTER
To the parallel
port on PC