Removing The Machine; Removing Protective Tape, Packing And Other Shipping Materials/Installing The Control Panel - Konica Minolta bizhub C360 Installation Manual

V. Removing the machine
1. Unpack and remove the machine package.
2. Remove the machine, holding it by the locations
on the left side and the handles on the right side
as shown in the illustration and keeping it level.
Note:
Machine mass: 98 kg/216-1/16 lb
• Make available collective manpower of an
appropriate size for transporting the machine.
• When attaching the machine, as the reference
fit the machine with the corner A and B of the
paper feed cabinet.
When holding the transportation handles,
be careful not to catch your fingers in the
machine.
A0XWMXC102MA
A
B
A0EDIXC002DA
VI. Removing protective tape, packing and
other shipping materials / Installing the
control panel
1. Remove the protective tapes and the protective
materials.
A0EDIXC003DA
A0EDIXE037DA
2. Open the right door and remove the protective
sheet and packaging materials.
Note:
After removing the packaging materials, make
sure that the transfer roller assy is secured in
place. In the case of <NG>, press the transfer
roller assy into place so that it is secured as shown
in <OK>.
< OK > < NG >
3. Remove the packing bracket.
E-2
4. Install the furnished control panel.
Note:
Insert the hook of the control panel into the posi-
tioning hole of the machine.
5. Secure the control panel with a furnished screw.
A0EDIXC006DB
6. Connect the machine connector to the control
panel.
A0EDIXC007DA
A0EDIXC008DA
A0EDIXC009DA
A0EDIXC010DA