Installation Instructions For Amd K7 Clip - Intel Pentium 4 mPGA478 Installation Manual

Installation Instructions for AMD K7 Clip

Figure 1
Please add an adequate layer of heat sink paste on the
surface of the CPU. Remove the bracket of the cooler along
the direction of the arrow (Figure 1-2). The bracket should
Figure 1-1
Figure 1-2 Figure 1-3
be removed as that shown in Figure 1-3.
A
B
Figure 2
Place point A of the clip (Figure2-1)on point B at the bottom
of the cooler(Figure2-2).As Figure 2-3.
Figure 2-1 Figure 2-2 Figure 2-3
Figure 3
Align the three spaces on the cooler with the three clips on
the base of the CPU and make sure point A of the clip
(Figure 2-1) is placed on point B at the bottom of the cooler
(Figure 2-2) and push down on the clip until it's firmly
Figure 3
locked.
Figure 4
Repeat the steps in "Power Installation and 3.5"
Fan Speed Controller Installation (Figure 2-1~Figure 4-2)".
Figure 4
The installation is now completed.
- 12 -
GH-PDU21-MF