Rj-45 Lan Connector Leds; Hi-Speed Usb 2.0 Support; 10/100/1000 Gigabit Ethernet Lan Connector Leds - Intel D975XBX Product Manual

Intel Desktop Board D975XBX Product Guide

RJ-45 LAN Connector LEDs

Two LEDs are built into the RJ-45 LAN connector located on the back panel (see Figure 2).
Table 4 describes the LED states when the board is powered up and the 10/100/1000 Gigabit
Ethernet LAN subsystem is operating.
Table 4. RJ-45 10/100/1000 Gigabit Ethernet LAN Connector LEDs
LED LED Color
A Green
B N/A
Green
Yellow

Hi-Speed USB 2.0 Support

NOTE
Computer systems that have an unshielded cable attached to a USB port might not meet FCC
Class B requirements, even if no device or a low-speed USB device is attached to the cable.
Use a shielded cable that meets the requirements for a full-speed USB device.
The desktop board supports up to eight USB 2.0 ports via ICH7; four ports routed to the back
panel and four routed to two internal USB 2.0 headers. USB 2.0 ports are backward compatible
with USB 1.1 devices. USB 1.1 devices will function normally at USB 1.1 speeds.
USB 2.0 support requires both an operating system and drivers that fully support USB 2.0 transfer
rates. Disabling Hi-Speed USB in the BIOS reverts all USB 2.0 ports to USB 1.1 operation. This
may be required to accommodate operating systems that do not support USB 2.0.
16
A B
Figure 2. LAN Connector LEDs
LED State Indicates
Off LAN link is not established
On LAN link is established
Blinking LAN activity is occurring
Off 10 Mb/s data rate
On 100 Mb/s data rate
On 1000 Mb/s data rate
OM18177