Using Different Functions On The Front Panel - Sherwood RD-5405 Operating Instructions Manual

RD-5405(A)_ENG100217_RD-5503(g) 2010-03-30 오전 10:53 페이지 25

USING DIFFERENT FUNCTIONS ON THE FRONT PANEL

• You can use the different functions easily with the specific buttons on the front panel.
1.
Select the desired setting mode.
• Depending on the selected input source, each time this
button is pressed, the mode changes as follows and is
displayed for several seconds:
→ [PRESET → TUNE → ] CH LEVEL
OFF ← TONE < ← D/A SET> ←
(Current input display)
[ ] : Selectable only when the tuner is selected.
< >: Selectable only when the VIDEO 1, VIDEO 2 is selected.
3.
Set the selected mode as desired.
■When selecting "PRESET" (Preset tuning mode)
• Each time this knob is rotated, the preset station will be
tuned to.(For details, refer to "Tuning to preset stations" on
page 22.)
■When selecting "TUNE" (Auto/manual tuning mode)
• Depending on whether this knob is rotated over several
steps once or one by one slowly, Auto tuning or manual
tuning will function. (For details, refer to "Auto tuning" and
"Manual tuning" on page 21.)
■When selecting "CH LEVEL" (Channel level adjustment mode)
• You can adjust the current channel levels as desired.
(For details, refer to "Adjusting the current channel level" on
page 19.)
① Press the MODE button to select the desired channel.
② Rotate this knob to adjust the level of the selected channel
as desired.
③ Repeat the above steps ① and ② to adjust each channel
level.
4.
Exit the setting mode.
2.
Enter the selected mode.
• The setting mode will be cancelled in several seconds.
Should this happened, perform the above step 1 again.
■When selecting "D/A SET" (Digital/Analog input mode)
• Each time this knob is rotated, the digital(optical or coaxial)
or the analog input will be selected.(For details, refer to
"When VIDEO 1, VIDEO 2 is selected as an input source" on
page 13.)
■When selecting "TONE" (Tone adjustment mode)
• Each time this knob is rotated, the tone mode is selected as
follows:
OFF : To listen to a program source without the tone effect.
↕
("DIRECT" indicator lights up.)
ON : To adjust the tone for your taste.
("DIRECT" indicator goes off.)
◆When the TONE is set to ON to adjust the tone
(bass and treble)
① Press the MODE button to select the desired tone.
② Rotate this knob to adjust the selected tone as desired.
③ To complete tone adjustment, repeat the above steps ①
and ②.
25