Sherwood RD-5405 Operating Instructions Manual page 17

RD-5405(A)_ENG100217_RD-5503(g) 2010-03-30 오전 10:53 페이지 17
When adjusting the sound parameters
• While playing digital signals from Dolby Digital program source or listening in Dolby Pro Logic II Music mode, you can
adjust their parameters for optimum surround effect.
1.
Press the SOUND PARAMETER button.
• Then "NIGHT : ~ " (or "PANO : ~ ") is displayed for several
seconds.
• If the parameter mode disappears, press this button again.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to
select the desired parameter.
• Each time these buttons are pressed, the parameter mode
changes as follows:
→ "NIGHT" ↔ "PANO" ↔ "C.WIDTH" ↔ "DIMEN" ←
(Night mode) (Panorama mode)
• "NIGHT" can be selected only while playing digital signals
from Dolby Digital source.
• "PANO", "C.WIDTH" and "DIMEN" can be selected only
while listening in Dolby Pro Logic II Music mode.
(Center width control) (Dimension control)
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to
adjust the selected parameter as desired.
■When selecting the "NIGHT (Night mode)"
This function compresses the dynamic range of previously
specified parts of Dolby Digital sound track (with extremely
high volume) to minimize the difference in volume between
the specified and non-specified parts. This makes it easy to
hear all of the sound track when watching movies at night
at low levels. The night mode can be set in 11 steps from
0.0 to 1.0 (default value : 0.0).
■Note : In some Dolby Digital softwares, the night mode
may not be valid.
■When selecting the "PANO (Panorama)" mode
This mode extends the front stereo image to include the
surround speakers for an exciting "wraparound" effect with
side wall imaging.
Select "OFF" or "ON"(default value: OFF).
■When selecting the "C. WIDTH (Center width)"
control
This adjusts the center image so it may be heard only from
the center speaker, only from the left/right speakers as a
phantom image, or from all three front speakers to varying
degrees.
The control can be set in 8 steps from 0 to 7(default value :
3).
■When selecting the "DIMEN (Dimension)" control
This gradually adjusts the soundfield either towards the
front or towards the rear. The control can be set in 7 steps
from -3 to +3 (default value : 0).
4.
Repeat the above steps 2 and 3 to adjust other
parameters.
17