Connecting Your Dvd Recorder To The Tv; Connecting Only With The Antenna Cable - Philips DVDR80 Owner's Manual

Connecting the DVD Recorder
Prepar!ng the remote control for
operation
The remote control and its batteries are packed separately in the original DVD Recorder
packaging, You must install the batteries in the remote control - as described in the paragraph
below - before use,
Take the remote control and the enclosed batteries (2 AA
batteries).
Remove the battery compartment lid, insert the batteries, then
replace the battery compartment lid, Always install the +/- ends
of the batteries as indicated inside the battery compartment,
The remote control is now ready to use.
Its range is approximately 16-32 feet (5 to 10 meters).
'Correct aiming' of the remote control
In the following sections, you require the remote control for the first
time. When using the remote control always aim the front part of it at
the DVD Recorder, not the TV.
Tip
Connecting your DVD Recorder to the TV
The necessarycable connections must be made before you can record or playback TV programs
using your DVD Recorder
Connect the DVD Recorder directly to the TV. Connecting a video cassette Recorder between
the DVD Recorder and the TV could result in poor picture quality.
When you install your DVD Recorder for the first time, select one of the following options:
'Connecting with S-Video (Y/C)'
If your TV is equipped with a S-Video (SVHS) jack.
'Connecting only with the antenna cable'
If your TV has only an Antenna-In jack (no other audio and video in jacks) or you do not wish to
use any other cable. The TV's Antenna In jack may be labeled ANT IN, RF IN, 75 ohm, etc Check
your TV instructions for details
Connecting the DVD Recorder I I