Restore; 11 2. Input Setup; Fj Hdmlln Assign; Digitalin Assign - Denon AVR-1609 Owner's Manual

ENGLISH
•
HDMlln Assign
Digital In Assign
iPodAssign
Audio Delay
EXT. IN Subwoofer Level
Auto Preset Memory
Parental Lock
Edit Lock Code
2 HDt'112: TI)
Input Setup
HDt'l 11: DUD
*, :
"OVO" is displayed.
*
2 : "TV" is displayed.
[Display]
1-1-.-::--,
F -'- . - .
-I-n-~-"
.-l-:l-F---
[Input terminals]
.:W!&QJ
ltaLltd
[Assignable input sources]
I
DVD/HDP
1* ' 1
TV/CBL
1*
21
VCR
II
V.AUX
II
OFF
I
'r'es<
1
23
Press <l to start.
[Display]
1
- . - .
, = - - , : . - - - -
; 2.In 3.0F"
11
It is not possible to return to Amp Assign settings with Restore.
After running Auto Setup, if the Amp Assign setting has changed,
return to the setting when Auto Setup was run.
Test Tone Start
Press <l to select "Yes", then press <l
[>
to select "Auto" or
"Manual".
Then press 'V. Out put the test tone.
Auto :
Press <l
[>
to adjust the volume.
Manual: Press l:. 'V to select the speaker, then press <l
[>
to adjust
the volume.
When the adjustments are completed, press
ENTER
to finish the test
tone.
[Variable range]
i£'12d8 - (
fillS
I - .
+talB,
~
Operating from the remote control unit
Adjusting with the remote control unit using the test tones is only
possible in the "Auto" mode and only effective in the STANOARO
mode. The adjusted levels for the different modes are automatically
stored in the memory.
[Adjusting using test tones]
CD
Press
[TESn
Test tones are output from the various speakers.
®
Use <l
[>
to adjust so that the volume is equal for all speakers.
Q) When the adjustments are completed, press
[TESn
• When "System Setup" - "Speaker Setup" - "Surround Back
Speaker" setting (~page 22) is set to '" spkr", the surround back
speaker display is "SB".
• Speakers set to "None" in the Speaker Configuration settings are
not displayed.
• When" Channel Level" is adjusted, the adjusted values are set for all
the surround modes.
Input terminals
a
fJ
HDMI1 HDMI2
Defauh setting DVD/HDP TV/CBL
• With HOM!. the video and audio signals are transferred
simultaneously. (The HOMI audio signal is output from the monitor.)
At this time, set the input mode to "Auto".
• The audio signals input from the analog, digital and EXT. IN connectors
are not output to the monitor.
For details on how to select. set and cancel settings for each menu. see ·System setup operation- (Grpage
211.1
24