Front & Rear Panels - Integra DTR-8.4 Instruction Manual

DTR-8.4_En.book Page 9 Thursday, October 16, 2003 11:09 AM
Front & Rear Panels
Front Panel
1 B
Standby/On
Standby
Direct/
Pure Audio
Pure Audio U psampling
I J K
Phones
Zone 2 Level Rec Out
L M N
For detailed information, refer to the pages in parenthesis.
A
Standby/On button (38)
This button is used to set the DTR-8.4 to On or
Standby.
B
Standby indicator (38)
This indicator lights up when the DTR-8.4 is in
Standby mode, and it flashes while a signal is being
received from the remote controller.
C
Audio Selector button (53)
This button is used to select the audio input signal
format: analog, digital, or multichannel.
C D E
Zone 2 ( )
GRN
Rec ( RED )
Audio DVD Video 1 Video 2 Video 3 Video 4
Selector
VCR 1 VCR 2
Front door
Zone 2 Off Stereo Surround THX DSP Dimmer Memory FM Mode
Clear
O P Q R S T UVW X Y Z a b
F G
Video 5 Tape Tuner Phono CD Net Audio
Display
Setup Tuning Enter Preset Return
Digital S Video
D
Input selector buttons & indicators (51)
These buttons are used to select the following input
sources: DVD, VIDEO 1–5, TAPE, TUNER,
PHONO, CD, and NET AUDIO. The indicators
show the currently selected input source.
The indicators also show which input source is
selected for Zone 2, in which case they light up
green, or which input source is selected for record-
ing (REC OUT), in which case they light up red.
E
Display
See "Display" on page 11.
H
Master Volume
Push To Open
DTR-8.4
Push here to open the flap
Video 5 Input
Video L Audio R
c
9