Video Setup - Integra DTR-8.4 Instruction Manual

DTR-8.4_En.book Page 46 Thursday, October 16, 2003 11:09 AM
Basic Setup —Continued

Video Setup

This section explains how to assign the composite video/
S-Video inputs to input sources. You only need to change
these settings if you connect a video component to a
video input other than the default assignment listed in the
following table, or if you want to enjoy audio and video
from different sources. There are no other reasons to
change these assignments.
Analog audio
Input source
input (fixed)
DVD DVD
VIDEO 1 VIDEO 1
VIDEO 2 VIDEO 2
VIDEO 3 VIDEO 3
VIDEO 4 VIDEO 4
VIDEO 5 VIDEO 5
TAPE TAPE
TUNER TUNER
PHONO PHONO
CD
NET AUDIO NET AUDIO
If, for example, you want to watch the video component
connected to the DVD S VIDEO input while listening to
the CD input source, change the CD input source assign-
ment from Last Valid to DVD.
As another example, say you connect the audio output of
a satellite receiver to the CD input, and its video output
to the VIDEO 4 S VIDEO input, since the default video
assignment for CD is Last Valid, you'll need to change it
to VIDEO 4.
1
Press the [Input] button, and then
roll the scroll wheel to select the
input source you want to assign.
2 Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
46
Composite/
S-Video inputs
DVD
VIDEO1
VIDEO2
VIDEO3
VIDEO4
VIDEO5
Last Valid
Last Valid
Last Valid
CD Last Valid
Last Valid
3
Use the Up/Down [
tons to select "2. Input Setup,"
and then press the [Enter] but-
ton.
The Input Setup menu appears.
4
Use the Up/Down [
tons to select "3. Video Setup,"
and then press the [Enter] but-
ton.
The Video Setup menu appears.
Advanced Menu
2.Input Setup
Input:DVD
2-3.Video Setup
Input:DVD
a.Video
b.Component Video
The name of the currently selected
input source appears next to "Input,"
"DVD" in this case.
5
Use the Up/Down [
tons to select "a. Video," and
then use the Left/Right [
buttons to select a video input.
Select "----" if you don't want any
video to be output while an input source
is selected.
6
Press the [Setup] button.
The setup menu closes.
Note:
• If you select Last Valid, the video source remains the
same when you select another input source. For exam-
ple, if you set the VIDEO 1 input source to Last Valid,
then select the DVD input source, then select the
VIDEO 1 input source, you can watch a DVD while
listening to the audio from the component connected
to the VIDEO 1 audio inputs.
• This procedure can also be performed by using the
input selector buttons, [Setup] button, [
[ ] buttons, and [Enter] button.
]/[ ] but-
]/[ ] but-
:DVD
:INPUT1
Quit:|SETUP|
]/[ ] but-
]/[ ]
]/[ ]/[ ]/