Speaker Settings - Integra DTR-8.4 Instruction Manual

DTR-8.4_En.book Page 40 Thursday, October 16, 2003 11:09 AM
Basic Setup —Continued

Speaker Settings

Speaker Impedance
This section explains how to specify the impedance of
your speakers. Check the backs of your speakers or their
manuals to determine their impedance.
Note:
Before you change this setting, turn down the volume.
2, 3
1
Press the scroll wheel, and then
press the [Setup] button.
The main menu appears onscreen.
40
2
3
1
2–4
4
1, 5
5
Notes:
• This procedure can also be performed by using the
DTR-8.4's [Setup] button, [
tons, and [Enter] button.
Use the Up/Down [ ]/[ ] but-
tons to select "0. Hardware
Setup," and then press the
[Enter] button.
The Hardware Setup menu appears.
Use the Up/Down [ ]/[ ] but-
tons to select "1. Speaker Imped-
ance," and then press the [Enter]
button.
The Speaker Impedance menu appears.
Advanced Menu
0.Hardware Setup
0-1.Speaker Impedance
a.Minimum :6 ohms
Use the Left/Right [ ]/[ ] but-
tons to select:
4 ohms: Select if the impedance of any
one speaker is between 4 and
6 ohms.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Press the [Setup] button.
The setup menu closes.
]/[ ]/[ ]/[ ] but-