Enjoying Music Or Videos In The Remote Zone; Using The Buttons On The Dtr-8.3 - Integra DTR-8.3 Instruction Manual

Enjoying music or videos in the remote zone

Using the buttons on the DTR-8.3

1. Press the Zone 2 button on the DTR-8.3.
2. Select an input source.
After pressing the Zone 2 button, you must press an input source
button within 8 seconds. The indicator above the input source
button lights green. In this condition, even if you change the
input source for the main zone, the input source for the remote
zone (Zone 2) will not change.
Ex.: When the CD button is pressed.
To select the same source for the remote zone that is selected
for the main zone, press the Zone 2 button again until "Z2
Sel:SOURCE" appears in the display. In this condition, if you
change the input source for the main zone, the input source for
the remote zone (Zone 2) will change as well.
When "Z2 Sel:Off" is displayed, the output to the remote
zone is turned off.
40
ZONE 2 indicator
Off
Input source buttons
Zone 2
Notes:
• If a sleep time is set with the Sleep button, the output to the
remote zone will also turn off when the sleep time elapses.
• The ZONE 2 terminal is an analog output. Digital signals are not
output. If no sound is heard from the selected input source, check
if the component is connected to the analog inputs.
• If the Rec Out button is pressed in the main room while someone
is using the system in the remote zone, the Zone 2 function will
be deactivated and the source will turn off in the remote zone.
• If you select FM (or AM) with the Tuner input source buttons
when the source for the remote zone (Zone 2) is set to AM (or
FM), the output for the remote zone also changes to AM (or FM).
• 7.1-channel playback in the main room is disabled if the Surr
Back/Zone 2 setting in the Surr Back/Zone 2 sub-menu of the
Hardware Setup Menu is set to "Zone 2."
• When you are using the remote zone (Zone 2),
operation will not work.
• When you are using the remote zone (Zone 2), the Pure Audio
setting will not work.
• When you are not using the remote zone (Zone 2), press the
Zone 2 button and then press the Off button to turn off the
Zone 2 indicator. (Using the remote controller, press the
Zone 2 button and then the Standby button.)
L
system