Integra DTR-8.3 Instruction Manual page 20

Connecting to Audio/Video equipment
Digital audio input (optical)
Digital audio output (coaxial)
S Video input
Video input
7. DVD recorder, other digital video
recording device (VIDEO 2)
Video output
S Video output
Component video output
7. Connecting a DVD recorder or other digital video recording
device (VIDEO 2)
Using RCA video cables, connect the video output jack (composite)
of the device to the VIDEO 2 VIDEO IN jack of the DTR-8.3 and
connect the video input jack of the device to the VIDEO 2 VIDEO
OUT jack of the DTR-8.3. Or if the device has S video input and
output jacks, connect them to the VIDEO 2 S VIDEO IN and OUT
jacks of the DTR-8.3 using S video cables. Or if the device has
component video outputs, connect them to one of the banks of
COMPONENT VIDEO INPUT jacks on the DTR-8.3.
With the initial settings of the DTR-8.3, the VIDEO 2 input
source is set for the COMPONENT VIDEO INPUT 2 jacks.
If you connect the device to the COMPONENT VIDEO INPUT 1
jacks, this must be changed at Setup Menu → Input Setup → Video
Setup → Component Video (see page 51).
Using RCA audio cables, connect the audio output jacks of the
device to the VIDEO 2 AUDIO IN jacks of the DTR-8.3 and connect
the audio input jacks of the device to the VIDEO 2 AUDIO OUT
jacks of the DTR-8.3. Make sure that you properly connect the left
channels to the L jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the DIGITAL
INPUT COAX jack or DIGITAL INPUT OPT jack of the DTR-8.3
depending on the type of connector on the device.
With the initial settings of the DTR-8.3, the VIDEO 2 input
source is set for digital input at the COAX 3 jack.
If the digital connection is made at a different jack, this must be
changed at Setup Menu → Input Setup → Digital Setup (see page
49).
If the device has a digital input, connect it to the DIGITAL OUTPUT
OPT jack of the DTR-8.3 for digital recording of the REC OUT
signal from the DTR-8.3.
20
R (red)
Analog audio
input
L (white)
R (red)
Analog audio
output
L (white)
Y
P
B
P
R
DIGITAL
PRE
AUDIO
INPUT TENNA R
COAX FRONT
1
R L
SUB
AM
2
OUT
SURR
3 IN
SURR
R
BACK/
OPT
ZONE 2
FM
1 OUT
75
FRONT
2 IN
UDIO
R
L
SUB
3 PHONO OUT
SURR
4 CD IN
R
OUT
OPT
1 IN
SURR
BACK
TAPE
2 IN
IN
GND
L R L
UDIO AUDIO
DIGITAL
OUTPUT
Note:
The output from the DIGITAL OUTPUT jack of the DTR-8.3 is
only the digital signal input to the DIGITAL INPUT jack.
: Signal flow
COMPONENT
VIDEO S VIDEO
VIDEO
OUTPUT
MONITOR
OUT
Y
ZONE 2 P
B
DVD P
R
INPUT 1
Y
VIDEO 1
P
B
P
R
VIDEO 2
INPUT 2
Y
VIDEO 3 P
B
VIDEO 4
P
R
VIDEO S VIDEO