Enjoying Music In The Remote Zone; Playing Music Using The Buttons On The Dtr-7.2; Selecting An Input Source Using The Remote Controller - Integra DTR-7.2 Instruction Manual

Enjoying music in the remote zone

Zone 2 indicator
Display
Standby/On
Standby
Power
On O f f
Direct
U psampling
Phones Zone 2 ( GRN )
Rec ( RED )
Audio DVD Video 1
Selector
VCR 1
Input source buttons

Playing music using the buttons on the DTR-7.2

1. Press the Zone 2 button on the DTR-7.2.
2. Select a source.
After pressing the Zone 2 button, you must press an input source
button within 5 seconds. The Zone 2 indicator lights.
Ex.: When the CD button is pressed.
To select the same source for the remote zone that is selected
for the main zone, press the Zone 2 button again until
"Zone2Sel:SOURCE" appears in the display.
When "Zone2Sel:Off" is displayed, the output to the remote
zone is turned off.
Notes:
• If a sleep time is set with the SLEEP button, it will also work for
the remote zone.
• If the source for the main zone is selected as the source for the
remote zone and the source for the main zone is changed, then
the source for the remote zone will change as well.
• The Zone 2 terminal is an analog output. Digital signals are not
output. If no sound is heard from the selected input source, check
if the component is connected to the analog inputs.
• If the Rec Out button is pressed in the main room while someone
is using the system in the remote zone, the Zone 2 function will
be deactivated and the source will turn off in the remote zone.
• If you select FM (or AM) with the input source buttons when the
source for the remote zone (Zone 2) is set to AM (or FM), the
output for the remote zone also changes to AM (or FM).
• When you are using the remote zone (Zone 2),
operation will not work.
• When you are not using the remote zone (Zone 2), press the Zone
2 button and then press the Off button to turn off the Zone 2
indicator.
54
Zone 2 Off
Dimmer Rec Out Zone 2 Of f
Se tup
Tun ing
Enter
Return
Preset
Stereo Surround THX DSP FM Mode Memory
A-FO RM Listening Mode Memory
Clear
Video 5 / Video Cam Input
Video 2 Video 3 Video 4 Video 5 Tape FM AM Phono CD
VCR 2
Digital S Video
SLEEP
Master Volume
Video L Audio R
Selecting an input source using the remote
controller
Turning on the Zone 2 and putting it in the standby state
when the DTR-7.2 is in the standby state:
After pressing the ZONE 2 button, press the ON/STDBY button
within 5 seconds.
Selecting an input source:
After pressing the ZONE 2 button, press an input source button
within 5 seconds.
If tuner is selected with the TUN button, the CH
enabled.
Notes:
• Adjust the volume for the remote zone at the pre-main amplifier.
• After you press the ZONE 2 button on the remote controller, the
Standby indicator on the DTR-7.2 flashes for five seconds.
During this time, you will not be able to perform operations in
the main zone using the remote controller.
system
ON/STDBY
INPUT SELECTOR
buttons
ZONE 2
HOME THEATER CONTROLLER
RC-461M
button becomes