Table of Contents
Advertisement
DTR-7.6,6.6.book Page 31 Monday, September 26, 2005 1:40 PM
Connecting Your Components —Continued
Connecting a CD Player
Step 1:
Choose a connection that matches your CD player ( ,
b
COAXIAL
IN 2
c
OPTICAL
IN 3
Connect one
or the other
• With connection
, you can listen to and record audio from the CD player and listen in Zone 2.
a
• To connect the CD player digitally, use connection
Connection
a
DIGITAL COAXIAL IN 2
b
DIGITAL OPTICAL IN 3
c
Connecting a Turntable
The AV receiver's PHONO IN is for use with a moving
magnet (MM) type cartridge.
Use an analog audio cable to connect the AV receiver's
PHONO IN L/R jacks to the audio output on your turn-
table.
Notes:
• If your turntable has a ground wire, connect it to the
AV receiver's GND screw. With some turntables, con-
necting the ground wire may produce an audible hum.
If this happens, disconnect it.
• If your turntable has a moving coil (MC) type car-
tridge, you'll need a commercially available MC head
amp or MC transformer. Connect your turntable to the
head amp or transformer, and connect that to the AV
receiver's PHONO IN L/R jacks.
• You can also use a phono equalizer to connect a turn-
table with an MC-type cartridge. See the phono equal-
izer's manual for details.
, or
a
b
a
IN
L
R
CD
COAXIAL
OPTICAL
OUT
or
b
AV receiver
Signal flow
⇐
CD IN L/R
⇐
⇐
), and then make the connection.
c
L
R
AUDIO
OUT
OUT
CD player
. (For Zone 2, use
and
c
a
b
CD
Analog audio L/R output
Digital coaxial output
Digital optical output
, or
and
.)
a
c
IN
L
R
PHONO
AUDIO
OUTPUT
L
R
31
Hide quick links:
Advertisement
Table of Contents
