Using The Remote Control In Zone 2 - Integra DTR-5.5 Instruction Manual

DTR-6.5,5.5_En.book Page 79 Wednesday, July 28, 2004 9:07 AM
Zone 2 —Continued
Using a Multiroom Kit with a Cabinet
In the following diagram, an IR receiver picks up the
infrared signals from the remote controller and feeds
them to the AV receiver in the cabinet via the connecting
block.
• On the Remote Setup menu, set the IR IN Position set-
ting to "Main" (see page 72).
Connecting
block
IR IN
Inside
cabinet
Signal flow
Controlling Out-of-range Components
If another AV component is out of range of its remote
controller, you can use a commercially available IR
emitter to retransmit the remote controller signals
received at the AV receiver's IR IN, as shown below.
Connecting
block
IR IN
IR OUT
DTR-6.5/5.5
IR Emitter
Other
component
Connect the IR emitter to the AV receiver's IR OUT, and
place the IR emitter in front of the other AV component's
remote control sensor (usually located on the front
panel), as shown below. See the instructions supplied
with the IR emitter.
Other component
from connecting block
Miniplug cable
Mini plug
DTR-6.5/5.5
Only remote controller signals received by the AV
receiver's IR IN are fed through to the IR OUT. Signals
picked up by the AV receiver's remote control sensor are
not output.
IR Receiver
Remote controller
IR Receiver
Remote controller
Signal flow
Remote control
sensor
Emitter
IR Emitter
Signal flow
79