Initial Setup; Digital Input - Integra DTR-5.5 Instruction Manual

DTR-6.5,5.5_En.book Page 42 Wednesday, July 28, 2004 9:07 AM
First Time Setup —Continued

Initial Setup

Digital Input

If you connect a component to a digital input jack, you
must assign that jack to an input selector. For example, if
you connect your CD player to the OPTICAL IN2 jack,
you should assign that jack to the CD input selector. By
default, the OPTICAL IN1 jack is assigned to the DVD
input selector, although this can be changed.
C D Tape
7
Phono
+ 10
--/---
Input Selector
Macro
1
1
Receiver DVD
Tape
T V VCR
Dimmer
2, 3
TV
Input
+
CH
Disc
-
Prev
CH
Display
Rec
Audio Subtitle
Surround All ST
Repeat A-B
Pure A Direct
Test Tone CH SEL
Open/Close Video Off
1
Press the [Receiver] button fol-
lowed by the [Setup] button.
Receiver
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "1. Initial
Setup," and then press [Enter].
Enter
The Initial Setup menu appears.
Enter
42
Tuner
8 9
TV VOL
0 Clear
2 3
Zone 2
Remote Mode
C D MD/CDR
Cable SAT
Sleep
2–4
Enter VOL
1, 5
Muting
Random
Angle Last Memory
THX Stereo
Search Memory
DSP DSP
Level- Level+
]/[ ]
3
Use the Up and Down [
buttons to select "1. Digital
Input," and then press [Enter].
Enter
The Digital Input menu appears.
Menu
------------------------
Basic Setup
1.Initial Setup
------------------------ 1.Initial Setup
2.Speaker Setup
1.Digital Input
Enter
1-1.Digital Input
2.Component Video ------------------------
Advanced Setup
3.Hardware Setup a.DVD
3.Surround Setup
b.VIDEO1
4.Audio Adjust
c.VIDEO2
5.Listening Mode Preset
d.VIDEO3
6.Preference
e.TAPE
f.CD
g.PHONO
• There are no assignments for
TUNER.
• VIDEO 4 is assigned to the optical
digital input on the front panel and
cannot be changed.
4
Use the Up and Down [
buttons to select an input selec-
tor, and then use the Left and
Enter
Right [ ]/[
digital input jack.
Examples:
If you connect your DVD player to the
OPTICAL IN 2 jack, set "a. DVD" to
"OPT2."
If you want to listen to audio from the
component connected to the OPTICAL
IN 3 jack when the VIDEO 1 input
selector is selected, set "b. VIDEO1" to
"OPT3."
If you want to listen to audio from the
component connected to the COAX-
IAL IN 1 jack when the VIDEO 2 input
selector is selected, set "c. VIDEO2" to
"COAX1."
For input selectors that you don't want
to assign a digital input jack, leave them
set to "-----."
5
Press the [Setup] button.
The setup menu closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
]/[ ]
:OPT1
:-----
:-----
:-----
:-----
:-----
:-----
]/[ ]
] buttons to select a