King Canada 8324 Instruction Manual page 6

ASSEMBLY
Your compound miter saw comes almost completely assembled, only the
dust bag, table lock knob and extension wings must be assembled.
ASSEMBLING DUST BAG
1. Slide dust bag assembly (A) Fig. 3, over dust spout (B) on rear of upper
guard assembly, as shown.
FIGURE 3
ASSEMBLING TABLE LOCK KNOB
1. Assemble the table lock knob (A) Fig.4 to the front support bracket (B).
2. Thread shaft into the opening.
3. Tightening completely will lock the table into position.
FIGURE 4
EXTENSION WING ASSEMBLY
The extension wings (A) Fig.5 are installed by inserting them into the
mounting holes on each side of the base. Push them in completely and
secure them into place by tightening the rear mounted lock knobs (B) on
each side of the base.
VISE ASSEMBLY
The vertical vise (A) Fig. 6 can be installed in two positions, either the left
FIGURE 5
or right side of the fence. Insert the vise rod into the hole in the fence and
tighten the vise lock knob (B) on the back to secure the vise rod.
FASTENING COMPOUND MITER SAW TO SUPPORTING SURFACE
Before operating your compound miter saw, make sure it is firmly
mounted to a workbench or other supporting surface. Four holes are
provided, one of which is shown at (C) Fig. 5, for fastening the saw to a
supporting surface.
When frequently moving the saw from place to place, we suggest that the
saw be mounted to a 1/2" or 3/4" piece of plywood. The saw can then be
easily moved and the plywood clamped to the supporting surface using
"C" clamps.
FIGURE 6