Recording From Video Components - Pioneer VSA-E03 Operating Instructions Manual

Other Operations

Recording from Video Components

The following operations show you how to record audio and video to the video tape recorder connected to the VCR
jacks.
The amplifier's volume, tone (BASS, TREBLE, MIDNIGHT and LOUDNESS), and surround effects have no
memo
effect on the recorded signal.
AMP TV
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT CD
VCR 1
TV CONTROL TUNER
VCR 2 AMP MD/TAPE
DSP MODE MIDNIGHT
1 2
3 4
CH.SELECT TEST TONE ATT SIG.SELECT
5 6 8
7
CH.LEVEL
EFFECT
9 0 +10
MEMU
CLASS TV/VCR
2
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
SIGNAL SELECT
2
34
En
1
Prepare the program source.
(Load the DVD or LD, etc.)
2
Select the component you want to record.
Be sure to press SIG. SELECT on the remote or SIGNAL SELECT on the
front panel to choose "ANALOG". (Refer to "Switching ANALOG/
DIGITAL signal input" on page 27.)
3
Insert a blank tape into the video tape recorder VCR.
4
Start recording on the video tape recorder, then start
SIG. SELECT playback from the source component.
memo
• Recording cannot be made from analog to digital, and similarly
from digital to analog.
• When recording a DVD, the recorded image may flicker or be
difficult to view because of the copy protection signal
programmed on the DVD.