Ajusting Bass And Treble (Tone Control) - Pioneer VSA-E03 Operating Instructions Manual

Sound Modes
Adjusting bass and treble (tone control)
Use BASS (–/+) or TREBLE (–/+) to adjust the low and high frequencies.
TREBLE –/+
BASS –/+
Adjusting the brightness of the display
Use FL DIMMER to adjust the brightness of the fluorescent display.
AMP TV
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT CD
VCR 1
TV CONTROL TUNER
VCR 2 AMP MD/TAPE
DSP MODE MIDNIGHT
1 2
3 4
CH.SELECT TEST TONE ATT SIG.SELECT
5 6 7 8
CH.LEVEL EFFECT
9 0 +10
MEMU
CLASS TV/VCR
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK
SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
32
En
Press BASS (–/+) to adjust the low frequencies.
SIGNAL
SELECT
ANALOG
Press TREBLE (–/+) to adjust the high frequencies.
SIGNAL
SELECT
ANALOG
memo
• The tone control can be adjusted in a range of ±6.
• Pressing + and – simultaneously restores the setting to 0.
• In cases described below, the tone control cannot be adjusted.
1 Dolby Surround mode is ON.
2 DSP mode is ON.
3 DVD 5.1ch input is selected.
4 Dolby Digital signals are being input.
Press FL DIMMER.
Four levels of brightness ranging from very dim to very bright can be
selected. Each press changes the brightness of the display. When rotating
through the options, the default brightness can also be selected.
memo
In standby, pressing
Surround button (both on the front panel) returns the display to the default
brightness.
FL DIMMER
SP A
dB
SP A
dB
STANDBY/ON while holding down (Dolby)