Playing Sources With Dolby Digital - Pioneer VSA-E03 Operating Instructions Manual

Playing Sources with Dolby Digital

AMP
1
FQ
+
ENTER
–
FQ
VOL
6
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT
2
VCR 1
TV CONTROL
VCR 2 AMP
DSP MODE
4
1 2 3
CH.SELECT TEST TONE ATT SIG.SELECT
6
5 7
3
CH.LEVEL
9 0 +10
CLASS
1
FUNCTION DIRECT
MODE CHECK
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1
memo
When playing LD recorded in Dolby Digital
When connecting a DVD/LD player or LD player using the AC-3 RF output, a commercially available RF demodulator
(RFD-1) is required. The RF demodulator changes the RF signal to a digital signal which is then processed by the
amplifier at the digital input jacks. For more details, refer to the instruction manual supplied with the RFD-1.
Refer to pages 42 for explanations of Dolby Digital, Dolby Pro Logic.
TV
1
Follow steps 1 to 3 of the playback procedure. (Refer to
"Playback" on page 28.)
1 Turn on the power of the playback component.
2 Press
3 Press FUNCTION to select the source component you want to
VOL
play.
2
CD
Press AMP.
TUNER
This sets the remote to select the sound mode.
MD/TAPE
MIDNIGHT
(You can skip this step when using the controls on the amplifier.)
4
8
EFFECT
3
Press SIG.SELECT on the remote control or SIGNAL
MEMU
TV/VCR
SELECT on the front panel to select DIGITAL.
FL DIMMER
COMMANDER
SET UP
(Refer to "Switching ANALOG/DIGITAL signal input" on page 27.)
Î
4
Press
Each press changes the Dolby Surround mode.
5
Start playback of the component you selected in step 1.
6
Press VOL (–/+) to adjust the volume level.
4
3 6
AMP to turn on the amplifier.
to switch the Dolby Surround mode on.
Sound Modes
29
En