Selecting A Sound Mode - Pioneer VSA-E03 Operating Instructions Manual

Sound Modes

Selecting a Sound Mode

To ensure the best possible surround sound, be sure to complete the set up procedures described in "Setting Up for
Surround Sound" (starting on page 14) before using the sound modes. This is particularly important when using the
(Dolby) Surround mode. When using the sound modes, SPEAKERS A are used. If SPEAKERS B are selected and a
sound mode is turned on, selection automatically switches to SPEAKERS A only.
Surrround operation
TV
AMP
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
CD
DVD/LD TV/SAT
VCR 1 TUNER
TV CONTROL
VCR 2 AMP MD/TAPE
DSP MODE MIDNIGHT
2
1 2 3 4
CH.SELECT TEST TONE ATT SIG.SELECT
6
5 7 8
CH.LEVEL EFFECT
9
0 +10
MEMU
CLASS TV/VCR
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
2
30
En
1
Press AMP.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the amplifier.)
2
Press DSP MODE to select the sound mode.
Each press changes the DSP mode as follows:
=HALL 1 = HALL 2 = JAZZ = DANCE
1
SFC OFF+ THEATER 2 + THEATER 1 +
memo
EFFECT –/+
• The amount of effect of each DSP mode can be adjusted in the range of 10
to 90 (the default setting value is 70) by pressing EFFECT –/+.