F3: Set - ATEN Master View CS-88A User Manual

CS-88A User Manual

F3: SET

This function allows the Administrator and each User to set up his own
working environment. A separate profile for each is stored by the OSD and is
activated according to the Username that was provided during Login.
To change a setting:
1. Move the highlight bar to it, then press [Enter].
2. After you select an item, a submenu with further choices appears. To make
a selection, move the Highlight Bar to it, then press [Enter]. An icon
appears before the selected choice to indicate which one it is. The settings
are explained in the following table:
Setting
OSD HOTKEY
PORT ID
DISPLAY
POSITION
PORT ID
DISPLAY
DURATION
24
Selects which Hotkey activates the OSD function:
[Scroll Lock] [Scroll Lock] or [Ctrl] [Ctrl].
Since the Ctrl key combination may conflict with programs running
on the computers, the default is the Scroll Lock combination.
Allows you to position where the Port ID appears on the screen.
The default is the upper right corner, but you can choose to have it
appear anywhere on the screen.
Use the Arrow Keys plus Pg Up, Pg Dn, Home, End, and 5 (on the
numeric keypad with Num Lock off), to position the Port ID display,
then press [Enter] to lock the position and return to the Set
submenu.
Note: The ID display position for each port on the installation is set
independently; the choice specified here only applies to the
currently active computer.
Determines how long a Port ID displays on the monitor after a port
change has taken place. The choices are: User Defined - which
lets you select the amount of time (from 1–255 sec.); and Always
On - which displays the Port ID at all times. If you select User
Defined, key in the number of seconds, then press [Enter]. The
default is 3 Seconds.
Function
(Continues on next page.)