What To Do If - Zanussi ZDTS 102 User Manual

What to do if...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
Fault code and malfunction
• continuous flash of the light of the run-
ning programme
• intermittent audible signal
• 1 flash of the end-of-programme indi-
cator light
The appliance does not fill with water
.
• continuous flash of the light of the run-
ning programme
• intermittent audible signal
• 2 flashes of the end-of-programme in-
dicator light
The appliance will not drain the water.
• continuous flash of the light of the run-
ning programme
• intermittent audible signal
• 3 flashes of the end-of-programme in-
dicator light
Anti-flood device operates
The programme does not start
After the check, switch on the appliance. The programme
continues from the point of interruption. If the malfunction
shows again, contact your Service Force Centre.
For other fault codes, not described in the chart, contact
your Service Force Centre.
These data are necessary to help you quickly and cor-
rectly:
• Model (Mod.)
12
Caution! Switch off the appliance before you do the
below suggested corrective actions.
Possible cause and solution
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• Close the water tap and contact your local Service Force Centre.
• The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........