Advertisement

User manual
Dishwasher
ZDTS 300

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZDTS300

  • Page 1 User manual Dishwasher ZDTS 300...
  • Page 2: Table Of Contents

    Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document.
  • Page 3: Safety Information

    Safety information • Under no circumstances should you attempt In the interest of your safety and to ensure the to repair the machine yourself. Repairs car- correct use, before installing and first using the ried out by inexperienced persons will cause appliance, read this user manual carefully, in- injury or serious malfunctioning.
  • Page 4: Control Panel

    Installation or if the control panel, work top or plinth area are damaged such that the inside of the ap- • Check your dishwasher for any transport pliance is freely accessible. Contact your damage. Never connect a damaged ma- local Service Force centre, in order to avoid chine.
  • Page 5 On/Off button Programme selection buttons Delay start button Indicator lights Function buttons Functions buttons the appliance MUST be in setting mode: In addition to the dishwashing programme se- • Press On/Off button, All programme light are lection, the following functions can also be set illuminated = the appliance is in setting with the help of these buttons: mode.
  • Page 6: Audible Signals

    Audible signals Audible signals have been introduced to help 3. Press function button C, the lights of func- indicate which operations the dishwasher is tion buttons A and B turn off while the light performing: of function button C goes on flashing. At the same time the end of programme in- •...
  • Page 7 4. Press the button corresponding to the re- Attention! Hot steam may escape when the quired programme (see "Washing pro- door is opened. Open the door carefully. grammes" chart). Interrupt a washing programme in pro- When a programme has been selected the gress: corresponding light will illuminate.
  • Page 8: Washing Programmes

    IMPORTANT! plugged and the water tap turned off. When the washing programme has finished, it is recommended that the dishwasher is un- Washing programmes Programme Degree of soil Type of load Programme description Intensive 70° Heavy soil Crockery, cutlery, pots Prewash and pans Main wash...
  • Page 9: First Use

    First use – Set the water hardness to level 1. Before using your dishwasher for the first time: IMPORTANT! • Ensure that the electrical and water connec- tions comply with the installation instructions If the drying results are not satisfactory we rec- •...
  • Page 10: Setting The Water Softener

    Water hardness Adjusting the water hardness Use of salt setting °dH °TH mmol/l manually electronically 51 - 70 91 - 125 9,1 - 12,5 level 10 43 - 50 76 - 90 7,6 - 8,9 level 9 37 - 42 65 - 75 6,5 - 7,5 level 8...
  • Page 11: Use Of Dishwasher Salt

    1. Press the On/Off button. The dishwasher 5 flashes / 5 intermittent audible signals, must be in setting mode. pause, etc...= level 5 6 flashes / 6 intermittent audible signals, 2. Simultaneously press and hold function pause, buttons B and C until the lights of the func- 6 flashes / 6 intermittent audible signals, tion buttons A, B and C start flashing.
  • Page 12 Unscrew the cap. Only before filling with Using the funnel provided, salt for the first time, fill pour in the salt until the the salt container with wa- container is filled with salt. ter. IMPORTANT! Immediately start a complete programme. IMPORTANT! Water will overflow from the container as salt is added.
  • Page 13: Use Of Rinse Aid

    Use of rinse aid Open the lid. Fill up with rinse aid. The Clean up any rinse aid maximum level for filling is which overflows. Close indicated by "max" the lid and press until it locks. IMPORTANT! CAUTION! Top up the rinse aid when the light on the control panel Never fill the rinse aid dispenser with any other sub- illuminates.
  • Page 14 • Before loading the dishes, you should: – To avoid damage to glasses, they must not touch. – Remove all left over food and debris. – Lay small objects in the cutlery basket. – Soften remnants of burnt food in pans •...
  • Page 15: Upper Basket

    Load cutlery. For best re- Place knives and other Load the lower basket. Ar- sults we recommend you items of cutlery with sharp range serving dishes and to use the cutlery grid pro- points or edges with their large lids around the edge vided (if the size and di- handles facing upwards.
  • Page 16: Use Of Detergent

    To move to the higher position proceed as follows: 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards until the mecha- nism is engaged and the basket is stable. To lower the basket to the original position proceed as follows: 1.
  • Page 17: Unloading The Dishwasher

    For programmes with pre- When using detergent Close the lid. wash add an additional tablets: place detergent detergent dose in com- tablets in compartment A. partmentB. Detergent tablets cleaning power during short washing pro- grammes. Therefore, please use long washing Detergent tablets from different manufacturers programmes when using detergent tablets, to dissolve at different rates.
  • Page 18: Cleaning The Spray Arms

    Clean filters A, B and C Turn the handle about 1/4 Remove filter A from the thoroughly under running turn anticlockwise and re- base of the washing com- water. move filters B and C. partment. Replace the filters and lock by turning the handle clockwise to the stop.
  • Page 19: Environment Concerns

    2. Leave the door ajar to prevent the forma- 1. Unplug it. tion of any unpleasant smells. 2. Turn the water tap off. 3. Leave the inside of the machine clean. 3. Remove the water inlet and discharge ho- ses. Frost precautions 4.
  • Page 20: What To Do If

    What to do if ... The dishwasher will not start or stops during solved with the help of the indications described operation. in the chart, without calling out an engineer. Certain problems are due to the lack of simple Switch off the dishwasher and carry out the fol- maintenance or oversights, which can be lowing suggested corrective actions.
  • Page 21 Once these checks have been carried out; For other fault codes not described in the above switch on the dishwasher. The programme will chart, please contact your Service Force Cen- continue from the point at which it was inter- tre. rupted.
  • Page 22: Technical Data

    Technical data Dimensions Width x Height x Depth (cm) 44,6 x 81,8-89,8 x 55,5 Electrical connection Information on the electrical connection is given on the rating plate on the Voltage - Overall power - Fuse inner edge of the dishwasher’s door. Water supply pressure Minimum - Maximum 0,05 - 0,8...
  • Page 23: Installation

    rinse aid respectively and using the test pro- gramme (see "Consumption values"). Full load: 9 standard place settings Amount of detergent required 5 g + 20 g (Type B) Rinse aid setting position 4 (Type III) Upper basket without smaller bowl Upper basket with smaller bowl and Cutlery basket and salad-bowl...
  • Page 24: Water Connection

    WARNING! WARNING! The dishwasher must be secured against tilting. Only use, for connection to the water mains, Therefore make sure that the counter it is fixed new hose-set; old hose-set must not be reused. under, is suitably secured to a fixed structure CAUTION! (adjacent kitchen units cabinets, wall).
  • Page 25: Drain Hose

    CAUTION! A water inlet hose with safety valve MUST only be replaced by your local Service Force Centre. Drain hose Connect drain hose to the Required height: 30 to 100 Ensure that the hoses are When connecting the sink. cm above bottom of the not kinked, crushed or en- drain hose to an under dishwasher.
  • Page 26 on the rating plate match that of the supply If necessary, have the domestic wiring system where the appliance is to be installed. socket replaced. In case that the electrical ca- The fuse rating is also to be found on the rating ble has to be replaced, contact your local Serv- plate.
  • Page 28 www.electrolux.com 117977680-00-31102007 Subject to change without notice...

This manual is also suitable for:

Zdts 300

Table of Contents