Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Zanussi ZDTS 102
Summary of Contents for Zanussi ZDTS 102
- Page 1 User manual Dishwasher ZDTS 102...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Setting and starting a washing programme _ _ _ _ 10 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... -
Page 3: Control Panel
• Do not change the specifications or modify this prod- Contact your local Service Force Centre. uct. Risk of injury and damage to the appliance. • Do not drill into the sides of the appliance to prevent • Do not use the appliance: damage to hydraulic and electrical components. -
Page 4: Washing Programmes
• To set the water softener. Refer to the chapter 'Setting • At the end of the washing programme. the water softener'. • When the appliance has a malfunction. • To deactivate/activate the audible signals. Refer to the The activation of the audible signals is set at the factory. section 'Audible signals'. -
Page 5: Use Of The Appliance
Programme Degree of soil Type of load Programme description Normal or light soil Crockery and cutlery Main wash up to 65°C Quick 65° A 30' Final rinse Normal soil Crockery and cutlery Prewash Eco 50° Main wash up to 50°C 1 intermediate rinse Final rinse Drying... -
Page 6: Setting The Water Softener
Setting the water softener The water softener removes minerals and salts from the • mmol/l (millimol per litre - international unit for the water supply. Minerals and salts can have bad effect on hardness of water). the operation of the appliance. •... -
Page 7: Use Of Dishwasher Salt
7. Press the programme selection/cancel button one 8. Press the on/off button to save the operation. time to increase the water softener level by one step. Use of dishwasher salt Caution! Only use dishwashers salt. Types of salt that are not applicable for dishwashers cause damage to the water softener. -
Page 8: Loading Cutlery And Dishes
Fill when the rinse aid in- Adjusting the dosage of rinse aid dicator (B) becomes clear. The rinse aid dial is set at the factory at position 4. To increase or decrease the dosage refer to 'What to do if...' Caution! Do not fill the rinse aid dispenser with other products (e.g. -
Page 9: Use Of Detergent
Arrange the items to let For longer items, fold the Do these steps to move the upper basket to the upper or water touch all surfaces. cup racks up. lower position: Adjustment of the height of the upper basket 1. Move the front runner stops (A) out. If you put large plates in the lower basket, first move the 2. -
Page 10: Setting And Starting A Washing Programme
tainers. In this condition the rinse aid indicator light stays on when the appliance is switched on. 1. Do a check if these tablets are applicable for the local water hardness. Refer to the instructions from the manufacturer. 2. Select the lowest setting for the water hardness and rinse aid dosage. -
Page 11: Care And Cleaning
• The appliance stops automatically. Let the dishes cool down before you remove them from the appliance. Hot dishes are easily damaged. • The audible signal for the end of the programme op- erates. Removing the load 1. Open the door. •... -
Page 12: What To Do If
What to do if… The appliance does not start or stops during operation. Caution! Switch off the appliance before you do the If there is a fault, first try to find a solution to the problem below suggested corrective actions. yourself. -
Page 13: Technical Data
The cleaning results are not satisfactory The dishes are not clean • The selected washing programme is not applicable for the type of load and soil. • The baskets are loaded incorrectly so that water cannot reach all surfaces. • Spray arms do not turn freely because of incorrect arrangement of the load. •... -
Page 14: Installation
Warning! To discard the appliance, follow the • Discard the door catch. This prevents the children to procedure: close themselves inside the appliance and endanger their lives. • Pull the mains plug out of the socket. • Cut off the mains cable and mains plug and discard them. -
Page 15: Electrical Connection
• Do not put the water inlet hose or the safety valve in water. • If the water inlet hose or the safety valve is damaged, immediately disconnect the mains plug from the mains socket. • Only let the Service Force Centre replace the water inlet hose with safety valve. - Page 16 To buy accessories, consumables and spare parts at our online shop please visit: www.zanussi.co.uk www.zanussi.com...