Factory Test Mode - GE Profile Harmony WPGT9360 Technical Service Manual

Factory Test Mode

The factory test mode allows the service technician
to make adjustments and run several important
tests on critical washer components.
1. Press the POWER pad to turn the washer on.
Press the HOME pad to ensure the home screen
is displayed.
TOUCH TO SELECT WASH CYCLE
COLOR
BY
SPECIAL
BY
FABRIC
CYCLES
2. Press the HELP pad. The main help screen is
displayed.
MACHINE
PREFERENCES
TROUBLESHOOTER
3. Press the HELP and START/STOP pads
simultaneously for 3 seconds. The Factory Test
Mode screen is displayed.
4. Press TEST LOAD on the LCD screen.
SPIN CYCLE
FILL/DRAIN/
SPIN
SPIN/
BRAKE
TEST LOAD
GARMENT
BY
STAIN
INSPECTOR
HOME SCREEN
HELP
CONTINOUS
SPIN
PROGRAM
CYCLE
LQC SPIN
LQC ALPHA
– 44 –
5. The contrast screen is displayed. This test
shows screen resolution, which affects how
the washer's graphics are displayed. Press the
START/STOP pad once to cycle through the
contrast screen (the black fl ips to the opposite
side).
6. Press the START/STOP pad. The TEST LOAD
screen is displayed.
TEST LOAD
TEST BRAKE RESISTOR
7. Using the TEST LOAD screen:
Note: Read this section completely before using the
TEST LOAD screen.
a. Press the START/STOP pad to scroll through
the test list.
TEST LOAD
TEST BRAKE RESISTOR
TEST COLD VALVE
TEST HOT VALVE
TEST BLEACH VALVE
TEST SOFTNER VALVE
TEST SPECIAL ADDITIVE
WATER - LEVEL FREQUENCY
259
DRY LOAD SENSING DATA
124 002 140 002 237 003 122 003 067
139 047 038 038
TEST PUMP MOTOR
IPM TEMP
032
ATM TEMP
040
WATER TEMP
020
CONTRAST
90
IPM TEMP
032
ATM TEMP
040
WATER TEMP
020
CONTRAST
90