Makita 2704 Instruction Manual page 8

Sub table (back)
(optional accessory for other than European
countries)
1
2
006212
To use the sub table (back), loosen the screws on the left
and right hand sides under the table and pull it out
backwards to the desired length. At the desired length,
tighten the screw securely.
NOTE:
When using the sub table (back ) during use of the
•
rip fence, pull out the sub table (back) more than
50 mm so that it does not hit against the top end of
the rip fence.
Sub table (L) (optional accessory)
1
006151
Sub table (L) (optional accessory) can be installed on
the left side of the table to obtain wider space.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
The tool is shipped from the factory with the saw blade
and blade guard not in the installed condition. Assemble
as follows:
Installing or removing saw blade
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing the blade.
1. Sub table (back)
2. Screw
2
1. Screw
2. Sub table (L)
2
1
Use only the Makita socket wrench provided to
•
install or remove the blade. Failure to do so may
result in overtightening or insufficient tightening of
the hex bolt. This could cause an injury.
Use the following saw blade. Do not use saw
•
blades which
characteristics specified in these instructions.
For Model Max. dia.
2704 260 mm
006585
CAUTION:
Check the arbor hole diameter of the blade before
•
installing the blade. Always use the correct ring for
the arbor hole of the blade you intend to use.
3
006135
Remove the table insert on the table. Hold the outer
flange with the offset wrench and loosen the hex nut
counterclockwise with the wrench. Then remove the
outer flange.
Assemble the inner flange, ring, saw blade, outer flange
and hex nut onto the arbor, making sure that the teeth of
the blade are pointing down at the front of the table.
Always install the hex nut with its recessed side facing
the outer flange.
1 2
006137
For all countries other than European countries
CAUTION:
The silver ring 25.4 mm in outer diameter is
•
factory-installed onto the spindle. The black ring 25
mm in outer diameter is included as standard
equipment. Before mounting the blade onto the
spindle, always be sure that the correct ring for the
arbor hole of the blade you intend to use is
8
do not comply
Min. dia. Blade thickness
230 mm 1.8 mm or less 2 mm or more
1. Offset wrench
2. Hex nut
3. Wrench
1
2
1. Inner flange
4 5 2. Ring
3. Saw blade
4. Outer flange
5. Hex nut
3
with the
Kerf