Installation - Hotpoint EG 900 X S Operating Instructions Manual

Installation

GB
! Before placing your new appliance into operation please
read these operating instructions carefully. It contains
important information concerning the safe installation and
operation of the appliance.
! Please keep these operating instructions for future
reference. Make sure that the instructions are kept with the
appliance if it is sold, given away or moved.
!
in accordance with the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the cooker has been disconnected from
the electricity supply.
Category: II 2H3+
Room ventilation
The appliance may only be installed in permanently-
ventilated rooms, according to current national legislation.
The room in which the appliance is installed must be
ventilated adequately in order to provide as much air as is
air must not be lower than 2 m
The air inlets, protected by grilles, should have a duct
with an inner cross section of at least 100 cm
be positioned so that they are not liable to even partial
These inlets should be enlarged by 100% - with a minimum
2
of 200 cm - whenever the surface of the hob is not equipped
provided in an indirect manner from adjacent rooms (see
as described above.
A
Examples of
ventilation holes
for comburant air.
A
! After prolonged use of the appliance, it is advisable to open
a window or increase the speed of any fans used.
Disposing of combustion fumes
guaranteed using a hood which is connected to a safe
fan which begins to operate automatically every time the
PLEASE PHONE US TO RE ISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS UARANTEE ON 08448 24 24 24
4
3
/h per kW of installed power).
2 and should
Adjacent Room to be
Room Vented
Enlarging the ventilation slot
between window and floor.
B
In a chimney stack or branched flue.
(exclusively for cooking appliances)
!
cylinders must have openings leading outside so that any
leaked gas can escape easily.
must not be installed or stored in rooms or storage areas which
are below ground level (cellars, etc.). Only the cylinder being
used should be stored in the room; this should also be kept well
away from sources of heat (ovens, chimneys, stoves) which
may cause the temperature of the cylinder to rise above 50°C.
Positioning and levelling
! The appliance may be installed alongside any cupboards
whose height does not exceed that of the hob surface.
! Make sure that the wall in contact with the back of the
material (T 90°C).
To install the appliance correctly:
(not in the bathroom).
appliance must be installed at least 500 mm away from them.
HOOD
600
Min. mm.
mm away from its sides.
instructions listed in the relevant operating manual.
Levelling
Directly to
the Outside
underneath a wall cabinet,
there must be a minimum
distance of 420 mm between
this cabinet and the top of
the hob.
This distance should be
increased to 700 mm if the
If it is necessary to level the
a p p l i a n c e , s c r e w t h e
adjustable feet into the
places provided on each
corner of the base of the