Troubleshooting - Hotpoint EG 900 X S Operating Instructions Manual

The time can also be changed in the following two ways:
GB
1. Repeat all of the foregoing steps.
2. Press the
buttons to reset the time.
Manual Operation Mode for the Oven
After the time has been set, the programmer is automatically
set to manual mode.
Note: Press the
mode after every "Automatic" cooking session.
Delayed Start Time with Preset Cooking Length
suppose that the display shows 10:00.
1. Turn the oven control knob to the cooking setting and
temperature desired (example: convection oven at 200°C).
2. Press the and the use (within 4 seconds) the
suppose that 30 minutes was set for the length of the
cooking time. In this case, the display will show:
Release the button, and within 4 seconds, the current time
will reappear with the
3. Press the button, and then use the
4. Release the button and the display will show the current
time within 4 seconds:
When "auto" is lighted, it indicates that the length and end
cooking time have been preset to operate in automatic mode.
At this point, the oven will turn on automatically at 12:30 in
the oven is on, the
the display for the entire length of the cooking process. The
button can be pressed at any time to display the setting
for the length of the cooking time, while the
be pressed to display the end cooking time.
At the end of the cooking time, an acoustic signal will
buttons).
Immediate Start Time with Preset Cooking Length
When only the length of the cooking time is set (points 1 and
2 of the paragraph entitled, "Delayed Start Time with Preset
PLEASE PHONE US TO RE ISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS UARANTEE ON 08448 24 24 24
10
button, and then use the
button to return the oven to manual
symbol and "auto."
and
symbol (cooking pot) will appear on
button can
Cancelling a Preset Cooking Time
Press the button, and use the
and
Then press the manual cooking mode button
Timer Feature
The timer can be used to count down from a given length
of time. This feature does not control when the oven comes
on or turns off, but, rather, it only emits an acoustic signal
when the preset time has run out.
Press the button, and the display will read:
and
Then use the
Release the button, and the timer will start at that second.
The display will show the current time.
At the end of the preset time, an acoustic signal will sound,
which can be turned off by pressing any button (except the
and buttons), and the
buttons
Changing and Cancelling Settings
corresponding button and using the
the end cooking time setting is also cancelled, and vice
versa.
accept end cooking times prior to the start cooking time
proposed by the appliance itself.
Buzzer volume control
button to adjust the volume of the alarm buzzer.

Troubleshooting

It may occur that the appliance does not function or does
not function properly. Before calling customer services for
assistance, let's see what can be done.
and
the gas and electrical supplies, and, in particular, that the
gas valves for the mains are open.
around the burner.
Check to make sure that:
mounted correctly;
button to set the time to:
and buttons to set the desired time.
symbol will turn off.
or
.
button.