Replacing The Oven Light Bulb - Hotpoint EG 900 X S Operating Instructions Manual

GB
has not been eliminated completely (for example when
grilling food, and the temperatures reached are not high
enough for the full self-cleaning action of the enamel to
be performed), we recommend you leave the oven on
at maximum temperature so that all grease residue and
the like are eliminated.
deposited on the self-cleaning oven walls, probably due to
your failing to follow the above maintenance advice, clean
the surfaces thoroughly with hot water and a soft cloth (do
not use any detergents), then rinse and dry thoroughly.
objects, as these could etch the self-cleaning coating.
or worn, due to incorrect or poor maintenance or after
many years of use, you can request a kit of self-cleaning
panels to line the inside of the oven. To order these, just
contact an authorised Service Centre.
printed symbols should not be cleaned with solvents or
abrasive detergents. It is advisable to use only a damp
cloth with lukewarm water and washing up liquid.
Stainless steel may remain stained if in long-term contact
with very calcareous water or aggressive detergents
(containing phosphorus).
It is therefore always necessary to rinse and dry all
surfaces thoroughly after cleaning.
Important: cleaning operations must be made
horizontally, in the direction of the steel glazing.
Important: do not use abrasive powders, aggressive
detergents or acidic substances for cleaning.
Hob:
be washed frequently with warm water and soap, making
sure to remove any caked-on substances. Check that the
gas outlet slits are not clogged. Dry the burners carefully
before using them again.
the hob and gas oven frequently.
Greasing the taps
In this case it will be necessary to clean inside and replace
the grease. This procedure must be performed by a
technician authorized by the manufacturer.
PLEASE PHONE US TO RE ISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS UARANTEE ON 08448 24 24 24
14
Disassembling/assembling the oven door
To make it easier to clean the inside of your oven, the oven
door can be removed, by proceeding as follows:
out the hooks "A
To reassemble the door:
"A" into the slots;
D" is hooked perfectly onto the edge of the
slot (move the oven door backwards and forward slightly);
downwards and then shut the door again.

Replacing the oven light bulb

- Voltage 230 V
- Wattage 15 W
- Type E 14.
! Do not use the oven lamp as/for ambient lighting.
B";
B"
Make sure that the appliance
is disconnected from the
electricity supply.
Unscrew the glass protective
cover from inside the oven,
u n s c r e w t h e l i g h t b u l b
and replace it with an
identical one suitable for
high temperatures (300°C)
and with the following
characteristics: