Monessen Hearth BDV300 Installation And Operating Instructions Manual page 41

OptIONAL FAN BLOWER SyStEM
7. Secure the AC box to the control box using
screw provided. Figure 56
8. Plug in wiring harness to the back of AC box.
9. Connect the blower according to the wiring
diagram. Figure 57 NOtE: Be sure to use the
wires marked 'Blower'.
10. Replace glass frame .
11. Plug the AC box plug to the junction box. Figure
57
12. To test blower operation. Turn the fireplace
on. Turn blower on. The blower should turn on
within five (5) minutes. Refer to the operating
instructions on Signature Command remote
control for complete operation instructions.
Finishing
Re-install the lower access panel.
Blower
(300 W
Max)
Figure 57 - Blower Wiring Diagram
The black and white wires on the AC box wiring
harness are marked 'Blower', 'Light' and 'Aux'
It is important to use the wires marked 'Blower'
or the control will not work correctly.
Electrical Grounding Instructions: This appliance is
equipped with a three-prong (grounding) plug for
your protection against shock hazard and should
be plugged directly into a properly grounded three
prong receptacle.
Electrical connections should only be performed
by a qualified licensed electrician. Main power
supply must be turned off before connecting the
fan to the main electrical power supply or perform-
ing service.
54D0700
To Junction Box
In Fireplace
Optional
{
Light WHITE
BLACK
WHITE
BLACK
{
BLACK
Optional
WHITE
AUX
Screw
AC Box
Connector Hole
Figure 56 - Connect AC Box to Control Box
FP1916
AC box
8/08
GREEN
FP2103
BDV fan wiring
BDV Series Gas Fireplace
Connector Pin
Guiding Block
Control Box
Optional
AC Box
Connector
Pin To Contro l Box
Control Box
FP2103
41