Safety 1st onBoard 35 Air User Manual page 25

4358-5480 US S1 onBoard Air 10/1/10
E-4 Installing Base with Vehicle Belts
Belt lock off MUST be used when using this base.
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Store LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
1.
2.
47
10:27 AM Page 49
Store LATCH Belts
You MUST store the LATCH
system when using the
vehicle seat belts. See
section D-7.
Place Base in Vehicle
Rear-Facing
Center the base in the
chosen seating position.
3.
Unlock the Belt Lock
Lift up on the belt lock off
lock.
Remove the lock from the
plates.
Tip: Push down on the
top cover to help make it
easier to open the lock.
4.
Lift Up Belt Lock Off
Plate "A"
5.
Thread Vehicle Belt
Thread the vehicle lap or
lap/shoulder belt
combination through belt
path as shown.
With an ALR belt, pull the
belt all the way out before
threading the base.
continued on next page.
48