Setup Procedure Before Setting Up - Panasonic DP-130 Operating Instructions Manual

Setup Procedure
Before Setting Up
Unpack and install on a stable flat surface.
Note: Do not plug the copier until directed to do so.
Set up the main unit with following procedure
# Remove all shipping tape and styrofoam.
$ Release the scanner/Remove shipping materials (See page 11)
% Installation of the Toner Cartridge (See page 12)
& Loading paper (See page 13)
( Install the copier in an area that means or exceeds the minimum space requirement
ATTENTION
10
Copier
Toner Cartridge
(1 piece)
(see diagram below).
Use only the setup units/parts designated by Panasonic. If the copier should be
C
damaged by using other setup units/parts, Panasonic will not bear any responsibility.
Drum unit already comes installed in copier.
C
10 cm
30 cm
Exit Tray Copier
Operating Instructions
(1 piece)
70 cm
Sheet Bypass