Connecting The Monitor; Connecting The Mouse - Fujitsu Siemens Computers SCENIC Edition X100 Operating Manual

Connecting the monitor

► Follow the instructions contained in the monitor manual to prepare the monitor for operation
(e.g. connecting cables).
► Plug the data cable into the monitor port
► Depending on your device configuration level, plug the monitor power cable into either the
PC (1) or the grounded mains outlet (2).
The monitor power cable may only be connected to the PC monitor socket if the monitor
!
current consumption is smaller than 1,5 A with 230 V or 3 A with 115 V. The values for the
monitor current consumption can be found in the technical data on the monitor or in the
operating manual for the monitor.

Connecting the mouse

Depending on the equipment level selected, your PC will be supplied with a PS/2 mouse or a USB
mouse.
Connecting a PS/2 mouse
► Connect the PS/2 mouse to the PS/2 mouse port
Connecting USB mouse
► Connect the USB mouse to the USB port
i
If you do not attach a mouse at the PS/2 mouse port
controller in the BIOS Setup in order to free the IRQ12 for a different application.
A26361-K678-Z121-1-7619, edition 1
of the PC.
1
of the PC.
of the PC.
, you can disable the mouse
Preparing for use
2
2
9