Troubleshooting And Tips; Installing New Software; Power-On Indicator Remains Unlit After You Have Switched On Your Device - Fujitsu Siemens Computers SCENIC Edition X100 Operating Manual

Troubleshooting and tips

Take note of the safety notes in the "Safety" manual and in the "Preparing for use"
!
chapter, when you connect or disconnect cables.
If a fault occurs, try to correct it as described in the following places:
● in this chapter
● in the documentation of the connected devices
● in the help systems of the software used
● in the documentation of your operating system
If you fail to correct the problem, proceed as follows:
► Switch the PC off.
► Make a note of the steps and the circumstances that led to the fault.
► Make a note of any error messages displayed.
► Note the ID number of your device.
This number can be found on the type rating plate on the back of the casing.
► Contact your sales outlet or our customer service centre.

Installing new software

When installing programmes or drivers, important files may be overwritten and modified. To be able
to access the original data in the event of any problems following installation, you should backup
your hard disk prior to installation.
Power-on indicator remains unlit after you have
switched on your device
This may be due to the following:
The mains voltage supply is faulty
► Check whether the power cable is properly plugged into the PC and grounded mains outlet.
► Switch the PC on.
Internal power supply overloaded
► Remove the PC's power cable from the grounded mains outlet.
► Wait for a moment.
► Plug the power cable into the grounded mains outlet again.
► Switch the PC on.
A26361-K678-Z121-1-7619, edition 1 27