Connecting The Monitor; Initial Switch-On: Software Will Be Installed - Fujitsu Siemens Computers PRIMERGY ECONEL 10 Operating Manual

Table of Contents

Connecting the monitor

Follow the instructions contained in the monitor manual to prepare the monitor for operation.

Plug the data cable of the monitor into the monitor port of the system unit.

Depending on the connector, plug the monitor power cable into either the system unit (1) or the

grounded power outlet (2).

You may only plug the monitor power cable into the monitor connector if the rated current

of the monitor is less than 1.5 A (230 V) or 3 A (115 V). The rated current for the monitor

is given on the monitor itself and in the Operating Manual for the monitor.

Initial switch-on: Software will be installed

If the PC is connected to a network, the network protocol is required as well as the user and server

details. Contact your network administrator if you have any questions about these settings.

When you switch on your PC for the first time the supplied software is installed and configured. You

should plan some time for this, as this process may not be interrupted.

Once the installation has been started the PC must not be switched off!

During installation the PC may only be rebooted when you are requested to do so!

Otherwise, the installation will be not be performed correctly. If a fault occurs in the

installation the contents of the hard disk must be completely restored.

You may need the license number for Windows during the installation. This number is located on a

sticker on your PC.

Switch the monitor on (see the Operating Manual for the monitor).

A26361-K831-Z100-1-7619

Preparing for use

Table of Contents