Table of Contents
Advertisement
Preparing for Use
Setting up the server
When installing your server, give consideration to the recommendations and safety notes
!
in the "Safety, Warranty and Ergonomics" booklet.
Set up the server only in its correct orientation. The points to observe are illustrated on the
following pages.
We recommend that you place your equipment on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is possible
that the rubber feet of the devices will mark the surface they stand on.
Do not expose the server to extreme environmental conditions (see chapter "Technical
data") and protect it from dust, humidity and heat.
Provide at least 200 mm of clearance on the left, in front of and behind the ventilator area
of the system unit to ensure adequate ventilation. Do not cover the ventilation areas of the
monitor and the system unit.
Do not place several system units one above the other.
Connect the monitor, mouse and keyboard
The ports for monitor, mouse and keyboard are on the rear and on the front of the system unit.
PS/2 keyboard port / purple
Monitor port / blue
Connecting the keyboard
Depending on the equipment level selected, your server will be supplied with a standard keyboard or
a USB keyboard.
Connecting standard keyboard
Use the supplied keyboard cable only.
Ê
Plug the other end of the keyboard cable (square plug) into the socket on the underside of the
keyboard.
Ê
Plug the round keyboard cable connector into the port marked with this symbol
system unit.
Connecting USB keyboard
Use the supplied keyboard cable only.
Ê
Plug the other end of the keyboard cable (square plug) into the socket on the underside of the
keyboard.
Ê
Insert the rectangular USB plug of the keyboard cable into the USB port
unit.
8
Setting up the server
PS/2 mouse port / green
USB port / black
on the system
A26361-K831-Z101-1-7619
on the
Advertisement
Table of Contents
