Surface Cooking; Cooktop Cartridge Installation; Grill Installation - Jenn-Air SVE47100 Instructions Manual

Surface Cooking
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Cooktop. Cartridge Grill Installation
Installation
The grill accessory consists of two black grill grates, a grill
Cooktop cartridges, either conventional coil, halogen or radi- element and two grill-rocks. It may be installed on the left
ant element, can be installed on either side of the range. (See side of the cooktop only.
page 23 for all available cartridges and model numbers.)
To Install Cartridges __ ':_
1. If the grill grates, element, and/or grill-rocks are in place, ....
remove before installing a cooktop cartridge. Clean porce- • !!_: 2_ ! ..... !!!
lain basin pan of any grease accumulation. (See page 21 for
To Install Grill
cleaning recommendations.)
2. To install any of the optional cooktop cartridges, be sure 1. Before installing grill components, be certain controls are
Off.
controls are turned Off. Position the cartridge terminal
2. Place the two grill-rocks into the left side empty basin pan
plug towards the terminal receptacle. This receptacle is
with their handles running parallel to the front of the range.
located at the front of the left side and at the back of the right (These grill-rocks must be used since they support the grill
side of the range, element.)
3. Slide the cartridge towards the receptacle until the cartridge
terminal plug is completely engaged. 3. Position the grill element with the terminal plug toward:
4. Lower the opposite end of the cartridge into the rangetop the terminal receptacle. This receptacle is located at tN
front of the left side. Slide the element towards tb_
until it is flush with the surface. Your range is now ready receptacle until the terminal plug is completely engaged
to use. The grill element should now rest on the handles of th_
To Remove Cartridges grill-rocks.
!, Controls must be Off and the cartridge should be cool. 4. Place the black grill grates on the top of the cooktop.
2. Lift up on the "tab" located on the cartridge until top of
To Remove Grill
cartridge clears the opening on the range by about 2 inches.
(Lifting the cartridge too high while still engaged in the 1. Be sure controls are Off. Remove grill components whet
receptacle could damage the terminal plug.) they are cool.
3. To disengage terminal, bold cartridge by the sides and pull 2. To remove grill element, pull away from receptacle until i
away from the terminal receptacle. Lift out when fully is unplugged. (Note: Lifting the element more than
unplugged, inches above the cooktop surface while it is engaged in th
4. A storage tray, Model A350, is available and can be used receptacle could damage the terminal plug.)
for storing a cartridge. 3. A storage tray, Model A350, is available for purchase an
can be used for storing the grill assembly.
5. Do not stack cartridges where they may fall or be damaged.
Never store other materials on top of the glass-ceramic Installing Other Grill Accessories
cartridges since this could damage or scratch the surface.
1. Remove the two black grill grates from the grill. Now yo
are ready to use the optional grill accessories.
U, arlll;i1 o 2. Review the instructions for installing and using the acces
Home
sories that are packaged with the accessory.
Note: Accessory options are shown on page 23.
Canning should be done on the conventional coil cartridge
only. Canning element accessory, Model A145A, makes it
possible to use large oversized canners with the conventional
coil cartridge.
For additional information, refer to use and care manual
packaged with your cartridge.