Britax MULTI-TECH II User Instructions page 17

Hide thumbs Also See for MULTI-TECH II:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
6i
6j
6k
6l
Installation of the child seat
IMPORTANT
– The child seat MUST always be used with a lap belt and
diagonal belt (approved according to UN/ECE Directive No. 16 or relevant
standards).
IMPORTANT
– Do not use any carrying points other than those described in
these operating instructions and those labelled in the child restraint equipment.
Place the child seat facing forward in your car.
Guide the diagonal part of the seatbelt through the dark red, top belt guide to
the
OTHER
side of the belt buckle
Pull the seatbelt horizontally over the child and fasten it
section should be on the red lap belt guides on both sides of the child seat.
Ensure that the harness is not twisted or loose.
IMPORTANT
– The lap belt should be positioned as far forward and as low as
possible over the child's pelvis.
IMPORTANT
– Check the position of the seat belt buckle and ensure that it is
not pulled around the child seat on the red lap belt guide
Check the position of the top seatbelt anchoring point in your vehicle
If this anchoring point is in front of the child seat, it should not be used. Try a
different position in the vehicle.
(Fig. 6i).
(Fig.
(Fig.
15-25kg
6j). The lap
6k).
(Fig.
6l).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Römer multi-tech ii

Table of Contents