Table of Contents
Advertisement
Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero). We recommend that you not change this setting. Some
operating systems will not run unless the boot device is set at zero.
Figure 3-6 shows the Boot Device Options screen.
Adaptec AIC7880 Ultra/Ultra W
Configuration
SCSI Bus Interface Definitions
Additional Options
Run SCSI Disk Utilities to get devices
in your system
Boot Target ID .............................................................................
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled------------
Boot Lun Number......................................................................... 0
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 3-6 Boot Device Options Screen
AIC-7880 Ultra/Ultra W at Bus:Device 00:10h
Host Adapter SCSI ID ................................ 7
SCSI Parity Checking................................. Enabled
Host Adapter SCSI Termination ................. Low ON/High ON
Boot Device Configuration
Boot Device Options .................................. Press <Enter>
SCSI Device Configuration ........................ Press <Enter>
Advanced Configuration Options................ Press <Enter>
<F6> - Reset to Host Adapter Defaults
SCSISelect (TM)
Chapter 3 - System Utilities 3-11
Utility
0
=default)
*
Advertisement
Table of Contents
