Table of Contents
Advertisement
Boot Options
This option allows you to specify your preferred settings for boot-up.
The following screen appears if you select Boot Options from the main menu:
Boot Sequence
1st [IDE CD-ROM]
2nd [Floppy Disk]
3rd [Hard Disk]
*First Hard Disk Drive............[IDE]
*Primary Display Adapter..........[Auto]
*Fast Boot .......................[Auto]
*Silent Boot .....................[Disabled ]
*Num Lock After Boot .............[Enabled ]
*Memory Test .....................[Disabled]
*Configuration Table .............[Disabled]
↑↓ = Move Highlight Bar
Esc = Exit
NOTE *: Can only be seen when press
Boot Sequence
This parameter allows you to specify the boot search sequence. To change the
order of devices, simply press
First Hard Disk Drive
This parameter specifies whether the BIOS utility will boot from an IDE hard disk
drive or a SCSI hard disk drive. The system will automatically boot from an IDE
hard disk if your system does not have a SCSI hard disk drive. The default
setting is IDE.
Primary Display Adapter
Setting this parameter to Onboard enables the on-board video controller.
Normally, the on-board video controller is considered as the primary display
adapter. If you installed a video card into your system, set this parameter to
Auto. BIOS will automatically disable the on-board video controller and
consider the video card as the primary display adapter.
Chapter 2
Boot Options
F1 = Help
→ ← = Change Setting,
8
.
]
[
or
.
37
Advertisement
Table of Contents
