Table of Contents
Advertisement
3.2.3
When to Use the SCSISelect Utility
Use the SCSISelect utility if you need to
•
Change any of the default values listed in Table 3-1
•
Check and/or change SCSI device settings that may conflict with those of
other devices (e.g., SCSI ID)
•
Perform low-level formatting on new SCSI disk devices
3.2.4
Running the SCSISelect Utility
To start SCSISelect, press Ctrl+A when the following is displayed during power-
up or reset:
Press <Ctrl> <A> for SCSI Select Utility!
This message appears after BIOS and POST information displays, and after the
banner listing the Adaptec AIC-7880 version number.
The SCSI devices displayed in the
SCSISelect Utility and their default values will
vary depending on the type of hardware
system it is running on..
Chapter 3 - System Utilities 3-5
Advertisement
Table of Contents
