Invacare Meteor Service Manual page 46

Invacare
®
Reassembly of steering linkage
ü
NOTE:
When reassembling the steering linkage, you must adjust it so that the steering is located
centrally and the tracking is parallel.
The stop must be adjusted when reassembling.
1. Fit the FROM linkage (to fork steering tube), washer
and TO linkage (to right-hand wheel) with the Allen
screw in the left-hand stub axle.
2. Screw the stop, washer and nut to the Allen screw
below the stub axle.
3. Fit the FROM linkage ball pin into the right-hand
stub axle, and fit the washer and nut.
4. Raise the FROM linkage.
5. Hold the ball pin on the FROM linkage up with flat-
nosed pliers and tighten the nut.
6. Fit the TO linkage ball pin into the fork steering tube,
and fit the washer and nut.
7. Raise the TO linkage..
8. Hold the ball pin on the TO linkage up with flat-
nosed pliers and tighten the nut.
46
Meteor
Service Manual